Rancent Tech RG59 Guia do Utilizador descarregar pdf (Página 8)

User’s Guide ADI-8 DS © RME

4.2 Quick Start Operation

After connection of all cables and power-on of the device, the configuration of the ADI-8 DS

begins in the CLOCK section. Choose a clock source and a sample rate.

Connect the TRS-jacks or the D-sub connector with the analog signal source. Change the input

sensitivity by pressing A/D REFERENCE until the input level is sufficient to avoid noisy opera-

tion. Try to achieve an optimum input level by adjusting the source itself. Raise the source’s

output level until the red Over LED flashes at the loudest parts of the signal, then reduce the

level a bit until no more Overs are detected.

The analog line inputs of the ADI-8 DS can be accessed by using D-sub (for an optional XLR

multicore) and 1/4" TRS jacks. Both are internally connected, so not operational at the same

time. The electronic input stage is built in a servo balanced design which handles unbalanced

(mono TS) and balanced (XLR, stereo TRS jacks) correctly, automatically adjusting the level

reference.

On the DA-side just choose the desired digital input by pressing D/A INPUT. A coarse correc-

tion of the analog output level can be done by pressing the D/A REFERENCE button.

The ADI-8 DS stores all current settings and automatically activates them when the device is

turned on.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Sem comentários

Rancent Tech RG59 Guia do Utilizador Página 8